I went back in and made sure at this point to finish and complete everything that I needed to do with the Fretboard as well. I had the 4 mm Allen wrench, and had been tweaking the truss rod per the previous session! As you can see from my previous post I used the bag of rice as my holder. I took out my fret rocker and wanted to make sure my guitar neck for high spots, and I began to spot level and had my rice bag on hand :-D.

I used my fret leveler that I had purchased from Amazon and worked through with my fret rocker and my fret leveler making sure to only push forward.

I then used my 1500 grit sandpaper to polish the fretboard and I used mineral oil to clean and then Feed n Wax to polish the fretboard.

Skills Required: Patience, Persistence and Precision

If I was to do this again, I would figure out the exact order it was best to do it all in! I think there was a bit of going back and forth figuring out what to do where in this whole process so that could have certainly been improved.